1、Furan resin - furan resin product (anti-corrosion type) this resin binder is a kind of high strength, good resistance to resist all organic solvent, the corrosion of acid and alkali resistant, is the ideal binder in epoxy, phenol, unsaturated polyester resin is incapable of such occasions, it by using some liquid rubber furan resin firming and furan resin powder two components. Furan resin, most liquid products used in acid and alkali, waterproof project can prevent the penetration and plant roots waterproof wear-resisting durable corrosion resistance, good heat resistance can be cured over 300 degrees, adhesive reliable performance, construction is convenient, used widely in anticorrosive engineering.
2、Furan Resin Plaster Technical Index
Appearance: tan viscous liquid
|
|
Viscosity: 15-1.5 seconds
|
Density ≥1.18/cm3
|
3、Furan resin curing agent powder technology index
Appearance:
|
Gray powder
|
Hardening of time
|
No more than 14 hours(20℃)
|
4、USE. Furan resin for building corrosion resistance, resistance to liquid carbonitriding layer, lining brick plate, corrosion and granite slabs of stone, furan resin concrete tank, pool, floor, etc. Also can be used for lining anticorrosive equipment metal protection
5、Construction are introduced
project
|
呋喃树脂胶泥
Ruran resin
|
呋喃树脂砂浆
Furan resin SAND STRACH
|
呋喃树脂玻璃钢
|
呋喃树脂胶 furan resin
|
1
|
1
|
1
|
呋喃树脂固化剂粉
|
3.5~4
|
|
|
呋喃树脂砂浆固化剂粉
|
|
2.5~2.7
|
|
呋喃树脂玻璃钢固化剂粉
|
|
|
1.0~1.5
|
6、Construction methods and inspection specification
This product is suitable construction viscosity, good workability, simple operation, easy construction. Construction methods and inspection norms, abide by the anticorrosion engineering technical specification furan resin CECS 01:19 88, building construction and acceptance of anti-corrosion GB 50212-2002
A、Stir furan resin, must be completed within 45 minutes, the dosage of MeiYiPan daub 2-3 kilograms advisable, To add furan curing agent, after mixing furan resin glue, after strict calculation, fully agitate rear can use. More than 30 degrees temperature environment should be appropriate for each dish configuration is reduced
B、Don't free agent to join other furan resin product. (furan resin firming agent has included in the powder),
C、The liquid furan resin viscosity, in construction, can try first deserve a dish with suitable for operation,. If you find consistency, cannot satisfy the requirement of construction can be adjusted, but not in the product after the initial thickened or hardening when adding furan resin glue mixing use second.
D、To strictly calculation furan resin glue with furan resin curing agent, the lowest ratio of powder in 1. 5 of not being supreme cannot prep above.
7、Furan resin performance of manufactured goods
Medium
|
Corrosion
degree
|
Medium
|
Corrosion degree
|
5~60% Sulfuric acid
|
Proof
|
10-50% Sodium hydroxide
|
Proof
|
37% Hydrochloric acid
|
Proof
|
Toluene
|
Proof
|
50% zinc sulfate
|
Proof
|
Water
|
Proof
|
20% acetic acid
|
Proof
|
Ethanol
|
Proof
|
5-10% Nitric acid
|
Proof
|
20-40% sulfuric acid
|
Proof
|
5-10% Chromic acid
|
Proof
|
30% Sodium chloride
|
Proof
|
5-10% phosphoric acid
|
Proof
|
10-15% Hydrogen peroxide
|
Proof
|
50% carbon bisulfide
|
Proof
|
20% ammonium hydroxide
|
Proof
|
chlorine(saturated)25℃
|
Proof
|
100% Chlorine 25 ℃
|
Proof
|
dimethoate
|
Proof
|
|
|
8、Main corrosion resistance
Tensile strength
|
Mpa
|
>8.0
|
Compression strength
|
Mpa
|
>70
|
Adhesive strength to tile
|
Mpa
|
>2.5
|
Curing speed
|
30℃,h
|
<24
|
heat-resistant
|
Homoiothermy ℃
|
>300
|
Breakdown voltage of strength
|
MV/m
|
17.5
|
9、Safe storage and packaging
Furan resin and furan resin curing agent, shall be stored in dry and cool, ventilated warehouse or construction site, and to prevent bask in the rain. Construction site to maintain good ventilated place, construction site may not open. Construction personnel should wear clothes wear mouth-muffle, glasses labor protection. In the original packaging barrels and conditions, furan resin and furan resin curing agent, respectively, mixed reaction, will solidify.
|
Furan resin is valid for one year (30-250 kg/barrel) : furan resin curing agent shall be valid for one year (25 kg/bag)
|
HEBEI FURAN INTERNATIONAL CO.,LTD.
Shijiazhuang Worldwide Furfural and Furfuryl ALcohol Co.,LTd.
Plant add:North Industry In Wuji County area, Shijiazhuang City , China